Numerische Berechnung einer integrierten Wärmebehandlung für das Gleitziehbiegen von Profilen und die experimentelle Umsetzung

authored by: B. A. Behrens, A. Bouguecha, M. Jeske, J. Moritz, M. Vucetic, T. Matthias
Abstract: With the help of the forming process of draw bending, a very wide range of profile components with variable cross sections can be established by using only one forming system and only one tool set. A local heat treatment can be used for a partial adjustment of the strength in the corresponding areas of the component at the same weight. This paper focuses on the simulation-based design of a combined draw bending process with a built-in heat treatment. Information regarding the process parameters and appropriate heating and cooling strategies could be provided with the help of FE calculations of the entire procedure before the design and construction phase of the experimental setup. Finally, the calculated designed process was experimentally achieved and validated.
Organisation(s): Institute of Metal Forming and Metal Forming Machines
Type: Article
Journal: HTM - Journal of Heat Treatment and Materials
Volume: 69
Pages: 339-347
No. of pages: 9
ISSN: 1867-2493
Publication date: 12.2014
Publication status: Published
Peer reviewed: Yes
ASJC Scopus subject areas: Industrial and Manufacturing Engineering, Metals and Alloys, Materials Chemistry
Electronic version(s): https://doi.org/10.3139/105.110242 (Access: Closed)
: Details in the research portal "Research@Leibniz University"